C7025 vs C7035: which Corson alloy for connector terminals
Use C7025 as the default: it covers most terminals at 620 to 860 MPa and at least 40 % IACS, and it is the more economical and more widely stocked grade. Move to C7035 when the design is thinner or smaller and still has to hold contact force: it reaches 770 to 970 MPa at about 50 % IACS.
Side-by-side data
| C7025 | C7035 | |
|---|---|---|
| UNS | C70250 | C70350 |
| Equivalents | EN CuNi3SiMg; JIS C7025 | EN CuNi1Co1Si; JIS C7035 |
| Composition % | Ni 2.2 – 4.2, Si 0.25 – 1.2, Mg 0.05 – 0.30 | Ni 1.0 – 2.5, Co 1.0 – 2.0, Si 0.5 – 1.2 |
| Conductivity %IACS | ≥ 40 | ≈ 50 |
| Tensile strength MPa | 620 – 860 | 770 – 970 |
| Tempers | TM00, TM02, TM03 | TM04, TM06 |
| Elastic modulus | 131 GPa | 131 GPa |
| Density | 8.82 g/cm³ | 8.82 g/cm³ |
Tensile strength is the range across supplied tempers. Full composition, tempers and physical properties are on each grade page.
Choose C7025 when
- Strip thickness is 0.15 mm or more and the contact force target is met at TM02 or TM03
- Cost and short lead time matter more than the last 100 MPa
- The part needs sharp bends: the softer tempers form more easily
Choose C7035 when
- The terminal is being miniaturised and thickness drops toward 0.10 mm or below
- The same contact has to carry more current: about 50 % IACS lowers temperature rise
- C7025 in its hardest temper is still short of the required normal force
Notes
Both alloys are precipitation hardened and supplied mill hardened, so no heat treatment is needed after stamping. Both resist stress relaxation well at connector operating temperatures. The difference is the strength ceiling and conductivity, which C7035 gains by replacing part of the nickel with cobalt.
Questions buyers ask
Can C7035 replace C7025 without changing the die?
Not always. C7035 is stronger, so springback and minimum bend radius change. Run a trial lot and check the formed dimensions before switching.
Need a recommendation for a specific part?
Tell us the part function, strip thickness and performance targets. We reply within one working day, and sample coils are available for comparative trials.
Material development support