Copper alloy strip for power tools and battery packs
We supply strip to the stamping plants and terminal makers that serve cordless tool, battery pack and charger programmes. The tables below give the grades usually specified for each kind of part.
Battery pack and charger terminals
A pack terminal carries the full motor current through a small contact area, so its temperature depends on the alloy’s conductivity as well as on the contact design. These grades combine high conductivity with the strength a spring terminal needs.
| Grade | UNS | Conductivity %IACS | Tensile strength MPa | Alloy |
|---|---|---|---|---|
| C19010 | C19010 | ≥ 55 | 360 – 590 | C19010 Copper-Nickel-Silicon Strip |
| C19720 | C19720 | 80 | 365 – 505 | C19720 High-Conductivity Copper Alloy Strip |
| C14415 | C14415 | ≥ 90 | 195 – 510 | C14415 Copper-Tin Strip (CuSn0.15) |
| C151 | C15100 | ≥ 90 | 245 – 490 | C15100 (C151) Copper-Zirconium Strip |
| C18140 | C18140 | 85 | 393 – 490 | C18140 Copper-Chromium-Zirconium Strip |
| C17510 | C17510 | 45 – 48 | 310 – 793 | C17510 High-Conductivity Beryllium Copper Strip |
Busbars, tabs and cell links
Switch, trigger and signal contacts
If a terminal runs hot
Tell us the material you use now, the current and the temperature you measure. We compare it with higher-conductivity grades of similar strength and send the figures. See terminals that run hot and power tool battery contacts.
How we supply stamping plants
- Strip slit to each width on your list, in the thickness and temper your tooling was set up for. Thickness by alloy: beryllium copper, copper-titanium and other high-performance alloys 0.03 mm to 0.25 mm; phosphor bronze and other alloys 0.08 mm to 1.8 mm; pure copper 0.10 mm to 6.0 mm.
- Quoted to the UNS, EN or JIS designation on your drawing; we confirm the equivalent before quoting.
- Every coil carries its lot number and ships with the test certificate, so incoming inspection has what it needs.
- Repeat orders against a forecast or a blanket order, shipped by sea or air. See export supply and supply to Europe.
- Samples and small qualification lots with the same documents as production shipments.
What to send for a quotation
Grade and temper, thickness and width with tolerances, monthly or annual quantity, and the destination port. If the grade is still open, send the part drawing and the current it carries and we will propose grades with the trade-offs.
Request a quotation
Send us the grade, temper, thickness, width and quantity. We reply within one working day.
Send RFQ